Siemens SITRANS P DS III - Page 157

Functional safety
8.7 PROFIsafe
SITRANS P DS III with PROFIBUS PA
Operating Instructions, 06/2013, A5E00053276-07
157
Procedure
1. Using the EDD, change the "PROFIBUS Ident Number" parameter from manufacturer
specific (3.01), PROFIsafe V1/V2 to manufacturer specific (3.01), PROFIsafe V1, if you
want to operate your devices with PROFIsafe V1.
Note
Write protection
Check whether or not write protection is disabled. If write protection is enabled, no further
configuration is possible, If write prote
ction is enabled, disable it.
2. Commission PROFIsafe as described in section PROFIsafe Commissioning (Page 145) .
Result
After downloading the data to the device, cyclic communication with the device is once again
possible.
See also
Activate and parameterize PROFIsafe with SIMATIC PDM (Page 146)
Commission PROFIsafe with SIMATIC PDM (Page 147)