Repair and maintenance
11.5 Disposal
SITRANS P DS III with PROFIBUS PA
184 Operating Instructions, 06/2013, A5E00053276-07
● Delivery note
● Return goods delivery note
(http://www.siemens.com/processinstrumentation/returngoodsnote)
with the following information:
– Product (item description)
– Number of returned devices/replacement parts
– Reason for returning the item(s)
● Decontamination declaration (http://www.siemens.com/sc/declarationofdecontamination)
With this declaration you warrant "that the device/replacement part has been carefully
cleaned and is free of residues. The device/replacement part does not pose a hazard for
humans and the environment."
If the returned device/replacement part has come into contact with poisonous, corrosive,
flammable or water-contaminating substances, you must thoroughly clean and
decontaminate the device/replacement part before returning it in order to ensure that all
hollow areas are free from hazardous substances. Check the item after it has been
cleaned.
Any devices/replacement parts returned without a decontamination declaration will be
cleaned at your expense before further processing.
The forms can be found on the Internet as well as in the documentation which comes with
the device.
Devices identified by this symbol may not be di
sposed of in the
municipal waste disposal services under observance of the
Directive 2002/96/EC on waste electronic and electrical
equipment (WEEE).
They can be returned to the supplier within the EC or to a
locally approved disposal service. Observe the
specific
regulations valid in your country.
Note
Special disposal required
The device includes components that require special disposal.
Dispose of the device properly and environmentally through a local waste disposal
contractor.
To Next Page
Loading...
Need help?
General
