Siemens SITRANS P DS III - Activate Write Protection Using PIN in SIMATIC PDM; Profisafe Commissioning

Functional safety
8.7 PROFIsafe
SITRANS P DS III with PROFIBUS PA
Operating Instructions, 06/2013, A5E00053276-07
145
8.7.6.2
Activate write protection using PIN in SIMATIC PDM
Requirement
The device is in the PROFIsafe commissioning status "S1".
Procedure for creating user-defined PIN
1. In the "Device" menu, select the "Write protection" command.
2. Click the "Change PIN" button.
An additional dialog opens.
3. Enter the desired PIN.
4. Click "OK".
The dialog closes.
5. Click the "ON" button.
6. Click the "Close" button.
Create default PIN
1. In the "Device" menu, select the "Write protection" command.
2. Click the "ON" button.
Result
The "Write protection" dialog is closed.
A user-defined PIN has been created for the write protection.
8.7.7
PROFIsafe Commissioning
Requirement
Before you commission the PROFIsafe device, configure it, for example in STEP 7.
Process
Activate and parameterize PROFIsafe with SIMATIC PDM (Page 146)
Commission PROFIsafe with SIMATIC PDM (Page 147)
Check write protection with SIMATIC PDM (Page 152)