Connecting up
5.2 Connecting the device
SITRANS P DS III with PROFIBUS PA
68 Operating Instructions, 06/2013, A5E00053276-07
1. Screw the covers ④⑦ back on as far as they will go.
2. Secure each cover with the cover catch
③⑥.
3. Close the key cover
①.
4. Tighten the screws in the key cover.
5. Check the tightness of the blanking plugs
⑤ and cable gland ② in accordance with the
degree of protection.
Cover (front), optionally with inspection window
Cover (rear) for electrical terminal compartment
Safety catch for stainless steel enclosure
Figure 5-2 View of the transmitter: Left: Back right: Front view
Structure (Page 24)
To Next Page
Loading...
