Silca Idea - Page 101

Copyright Silca 2004 97
Operating Manual - English IDEA
D IMENSION CHECK WITH C OPY FROM O RIGINAL
(after the Cutting Test)
After carrying out the Cutting Test, proceed as follows:
Choose 0 “Copy from Original” from the main menu and press ENTER.
Choose 0 “Bit stop M” and press ENTER.
Choose 1 “Reading + Cutting” and press ENTER.
Follow the instructions on the display.
Press START.
Follow the instructions on the display.
Fit the key blank into the clamp S1, then press START.
Press ENTER
Press STOP, remove the key and use a centesimal gauge to measure it.
0 - Copy from Original
1 - Decode and Copy
2 - Insert cuts
3 - Queue from PC >>
SELECT TYPE OF KEY
0 - Bit stop male
1 - Bit stop female
2 - Shoulder stop
1 - Reading + Cutting
2 - Cutting only
3 - Reading only
4 - Post-Reading adj.
KEY READING
Original on right
Clamp: S100 A-B Stop: 0
(START)
Reading in progress….
Date processing
in progress
Please wait…
Left blank Brass
Clamp: S1-K1 Stop: 0
Cutt.: 1.25
Pcs = 1/1 (START)
Cutting in progress
Copy: 1 of: 1
Copy 1 of 1
finished
More copies?
No=STOP Yes=ENTER