Silca Idea - Page 121

Copyright Silca 2004 117
Operating Manual - English IDEA
The key may not be perfect, due to a slight error in the
reconstruction of the key read.
Possible causes:
• some of the teeth on the key are deformed or crooked.
• there is dirt on the key that deforms the image of the
reconstructed bit (grease, swarf, threads of cloth).
Solution:
• clean the key carefully with a metal brush and repeat
the reading operation.
NOTE: In any case the key can be cut by pressing ENTER. There is no guarantee that the
reproduction will be an exact copy of the original key.
NOTE: If the error is repeated or the key is not properly reproduced, consult ch.7.14 "DIAGNOSTIC
FUNCTION – errors in: Copy from Original on IDEA", page 134, and/or contact Silca After-Sales
Service.
The key cannot be copied due to a SERIOUS error in the
reconstruction of the key read.
Possible causes:
• some of the teeth on the key are extremely deformed
or badly broken.
• there is dirt on the key that deforms the image of the
reconstructed bit (grease, swarf, threads of cloth).
Solution:
• clean the key carefully with a metal brush and repeat
the reading operation.
NOTE: If the error is repeated consult ch.7.14 "DIAGNOSTIC FUNCTION – errors in: Copy from
Original on IDEA", page 134, and/or contact Silca After-Sales Service.
A POST-READING adjustment has been incorrectly made
to a key read from an original. The error code
distinguishes the following situations:
1 – An X conversion has been applied to a single bit key
reading. An X conversion can be applied only to double
bit keys.
2 – A FRONT-BACK adjustment has been applied but the
reading algorithm is unable to identify the number of teeth.
ERROR 22
Key reading
is not optimal
ENTER to continue
ERROR 23
Key cannot be cut
due to reading error:
ERROR 24
Error in
post-reading adj.
Code: __