Silca Idea - Page 38

34 Copyright Silca 2004
IDEA Operating Manual - English
CUTTING PUMP KEYS
Operate as follows:
Clamp: S1 - K1 = indicates which clamp (S1) and tailstock (K1)
to use for gripping the key.
Stop 0 = reference or positioning point on the key cutting clamp.
Cutter: 1.25 = thickness of the cutter currently selected (press
SHIFT+ENTER to change thickness).
Adatt: E3 = special adapter for cutting PUMP keys.
Brass/Steel = material of the key (press SHIFT+? to change
material).
ATTENTION: always check that the wording corresponds to the
material of the key.
Fig. 40
The key blank to be cut must be positioned according
to the parameters given on the display after selecting
the program involved; the type of pump keys requires
the use of the
E3 adapter and the key reference on
"
Stop 3 ".
Please follow the instructions below carefully, and
observe the order of operations.
1) Loosen the knob (T1) by turning it anticlockwise
until the rotating clamp (S1) can be moved to a
convenient distance for fitting the key).
2) Take the ‘T’ wrench (T4) from its seat and fit into the
screw (V1), then loosen until the jaws are fully open.
At the end of the operation do not remove the ‘T’
wrench from the screw (fig. 41).
Fig. 41
3) Fit the key blank into the E3 adapter, paying
attention to its position (fig. ), then tighten the screw
(P).
4) Fit the
E3 adapter, with the key blank in the rotating
clamp (S1) from the inside, take the adapter up to
the side of the self-centring jaws and slightly close
the grips on the rotating clamp with the ‘T’ wrench
(T4).
5) Move the rotating clamp S1 so that the adapter
E3
enters the tailstock K1.
6) Tighten the knob (T1). Use the ‘T’ wrench (T4) to
tighten the screw (V1) first, then the screw (V2) (fig.
42). Replace the T wrench (T4) into its seat, lower
the mobile safety shield and begin the process with
START.
- To remove the key at the end of the cutting process,
carry out the same operations in reverse order.
Fig. 42
- You can now press ENTER in order to make further copies of the key.
- Select
STOP to quit.
Left blank Brass
Clamp: S1-K1 Stop:3
Cutt.: 1.25 Adapt.: E3
Pcs = 1/1 [START]
Cutting in progress
Copy: 1 of: 1
Copy: 1 of: 1 finished
More copies ?
No=STOP Yes=ENTER
Adapter E3
P
E
3
V1
V1
V2
E
3