Silca Idea - Page 64

60 Copyright Silca 2004
IDEA Operating Manual - English
6) Close the mobile clamp jaws slightly, using the T wrench
(T4) already in the screw (V1), without gripping the key stem;
move the rotating clamp (S1) towards the tailstock until the
adapter E15 goes into the hole in the stem keeping a
minimum safety distance of 10 mm between the rotating
clamp jaws and the rear limit of the bit. Secure the rotating
clamp in position by means of knob (T1).
7) Hold the key head in the left hand and align crosswise
making sure that the bit is all the way up against the adapter
E15 on the tailstock (K1), then close the grips round the key
stem, using the T wrench (T4) already in place on the screw
(V1).
8) Replace the T wrench (T4) in its seat, lower the mobile safety
shield and begin the process with START.
To remove the
key after cutting, carry out the operations described, in
reverse order
.
Fig. 86
- Pressing Start shows:
- When the reading process starts the carriage will take the key into contact with the laser beam along the path dictated
by the Software, at the end of the cycle see the message on the display in order to continue.
To make further copies of the key, you can now press ENTER.
Reading in progress…
Data processing
in progress
Please wait…
Cutting in progress…
Copy: 1 of: 1
Copy 1 of 1
finished
More copies ?
No=STOP Yes=ENTER
V1