Copyright Silca 2004 59
Operating Manual - English IDEA
Cutting
Clamp: S1- K1
= indicates which clamp (S1) and tailstock (K1) to use for gripping the key.
Stop 0
= reference or point for positioning the key on the cutting clamp.
Cutter: 1.25
= thickness of the currently selected cutter (press SHIFT+ENTER to change thickness).
Brass/Steel
= material of the key (press SHIFT+ ? to change material).
Adapter E15
= adapter (centring device) to position the tip of the key (female) properly. Fit into the K1 tailstock.
ATTENTION: always check that the wording corresponds to the material of the key.
The key blank to be cut must be positioned according to the
parameters given on the display after selecting the program
involved
;
the type of key with front stop requires the use of the
rotating clamp
(S1),
the ‘K1’ tailstock
,
the
E15
adapter and the
key reference on
“Stop 0”.
Please follow the instructions below carefully, and observe the
order of operations
.
1) Loosen the knob (T1) by turning it anticlockwise until the
rotating clamp (S1) can be moved to a convenient distance
for fitting the key.
2) Fit the adapter E15 into the tailstock K1 up against the
mechanical stop (fig. 85).
3) Use the T wrench (T4) to tighten the screw (V2) on the
tailstock and secure the E15 adapter.
Attention:
the adapter
E15 must be properly fitted into its seat and pressed up
against the stop point.
Fig. 84
4) Take the T wrench (T4) from its seat and open the rotating
clamp jaws by turning the sunk hex. screw (V1); at the end
of the operation leave the T wrench in the screw (V1).
5) Fit the key blank into the front side of the rotating clamp (S1)
and position it on the groove in the jaws, then take the key
forward until the adapter E15 goes into the hole in the stem
(fig. 86).
Fig. 85
Left blank Brass
Clamp: S1-K1 Stop: 0
Cutt: 1.25 Adapt: E16
Pcs. = 1/1 [START]
Is adaptor E15
installed ?
No=STOP Yes=START
To Next Page
Loading...
