Silca Idea - Page 94

90 Copyright Silca 2004
IDEA Operating Manual - English
Fig. 116
CUTTING UNIT
1) enter the “Maintenance” #5 .
2)
select “Machine zero points” #2 .
Operational keys:
use the arrow keys to move the cursor to the option
required and press ENTER or directly press the numbered
key corresponding to the option number.
3) select ‘Cutting unit’ #1 .
4)
insert the (Z12) template (fig. 99, page 74).
5)
remove the cutter and insert the (Z13) template into
place (
fig. 99 ) .
6)
manually move the X and Y axis up until the (Z12) and
(Z13) templates make contact
(fig. 117).
7)
lower the protective shield and press START .
ATTENTION: check that both the (Z13) and (Z12) templates make
perfect contact. If this does not occur the display will
show an error message.
Y axis photocell
Y axis sensor
Y axis photocell disk
J1
B5
1 - Test
2 - Machine ‘0’ point
1 - Cutting unit
2 - Reading unit
4 - Calibrations
5 - Maintenance
6 - Options
Install Z12 & Z13
templates.
See operating manual.
[ENTER]
Move axis
up until contact is made
See operating manual.
[START]
ERROR 10
No contact made.
See operating manual.
ENTER
START
ENTER