Silca Idea - Page 99

Copyright Silca 2004 95
Operating Manual - English IDEA
D IMENSION CHECK – CUTTING TEST
To check the machine’s precision, proceed as follows:
Choose “2 Insert cuts” from the main menu and press ENTER.
Choose SSN = 10 and press ENTER.
Enter the depth for bit 1 as in the example:
Press ENTER
Enter the depth for bit 2 (the same as bit 1) as in the example:
Press ENTER
Fit the key blank into the clamp S1, then press START.
0 - Copy from Original
1 - Decode and Copy
2 - Insert cuts
3 - Queue from PC >>
SSN = 10 (Cut)
Make =
= CISA
CSL-CSLC-5CS1-5CS2
Bit 1: 2 (Symm. F-R)
# #
Possible depths
123456# (1)
Bit 1: 2 (Symm. F-R)
111#66666#111
Possible depths
123456# (8)
Bit 2: 2 (Symm. F-R)
…#…..#…
Possible depths
123456# (1)
Bit 2: 2 (Symm. F-R)
111#66666#111
Possible depths
123456# (8)
SSN: 10 M1 Brass
Clamp: S1 – K1 Stop: 0
Cutter: 1.25
Pz. 1 / 1 (START)
Cutting in progress
Copy: 1 of: 1
Bit 1
Cutting in progress
Copy: 1 of: 1
Bit 2
Copy 1 of 1
finished
More copies ?
No=STOP Yes=ENTER