94 Copyright Silca 2004
IDEA Operating Manual - English
Fig. 122
5) lower the protective shield and press START.
- the ‘machine’s zero’ settings are detected by the optical
reader.
- when this operation is completed, the machine’s display
will show the measured quotes
ATTENTION: if the STOP key is pressed, the new settings will be
lost. If so, only the previous setting values will remain
valid.
Zero detection
in progress!
Measured quotes:
X=4444 Y=3333
Save measurements?
No=STOP Yes=ENTER
ENTER
START
To Next Page
Loading...
