Silca Idea - Page 97

Copyright Silca 2004 93
Operating Manual - English IDEA
Fig. 120
Fig. 121
R EADING UNIT
Operational keys:
use the keys to move the cursor to the option required
and press ENTER or directly press the numbered key
corresponding to the option number.
1) enter the ‘Maintenance’ menu #5 .
2)
select ‘Machine zero points” #2 .
3)
select ‘Reading unit’ #2 .
4) install the (Z14) template.
- install A and B clamps (S100)
bottom view
ATTENTION:
if it is necessary to work close
to this area with the machine
turned on (e.g. to regulate the
X axis sensor) take great care
not to touch any components
on the machine’s electronic
boards as it is connected to
230/110 Volts.
C3
Y axis sensor
C3
1 - Cutting unit
2 - Reading unit
Install A & B clamps
and Z14 template
See operating manual.
[START]
1 - Test
2 - Machine ‘0’ point
4 - Calibrations
5 - Maintenance
6 - Options