Simrad AP35 - Connecting a Reversible Pump; Connecting a Hydraulic Linear Drive; Figure 4-8 Connecting a Reversible Pump; Figure 4-9 Connecting a Hydraulic Linear Drive

Installation
22083083H 53
Note ! When selecting DRIVE UNIT voltage in the Installation setup, the
clutch/bypass voltage is always set equal to the motor voltage. If a retrofit
installation where e.g. a HLD2000 has a 12V motor and a 24V bypass valve,
the bypass valve solenoid has to be changed back to standard 12V version.
Connecting a reversible pump
Robertson
reversible
pump
JUNCTION UNIT
POWER PCB
TB1
TB2 TB3 TB4
TB5
TB6
Sol. -Motor Sol. -Motor
Figure 4-8 Connecting a reversible pump
Connecting a hydraulic linear drive
JUNCTION UNIT
POWER PCB
TB1
TB2 TB3 TB4
TB5
TB6
Bypass
Clutch
Sol. -Motor
Sol. -Motor
TB7
HYDRAULIC
LINEAR DRIVE
Single pole
clutch/bypass
switch
Figure 4-9 Connecting a hydraulic linear drive