Installation
22083083H 89
• If a Non-Follow Up lever (or handheld remote) is connected, test the
mode switching and verify Port and Stbd steering commands of the lever.
• Set waypoints into each navigator connected to the system, and verify
that the AP35 steers in NAV mode for each NAV source.
• Provide the owner with user training.
4.35 Providing user training
The user should be instructed in the "basic" operational functions, such as:
• Turning the system on and off
• Explain how to change modes (explain briefly what takes place in the
different modes).
• Regaining manual control from any mode. Point out in what modes the
helm is engaged by the autopilot (bypass/clutch).
• How to take command at an "inactive" station if applicable.
• Lock mode and how to lock/unlock and how to shut the system down
from a locked control unit if applicable.
• Show NFU and FU steering and show the difference.
• Review how to use a NFU controller if connected.
• Course change by rotary knob and buttons.
• Go through the user SETUP menu and show how to (and why) change
the settings.
• Also include Nav. source, Pos. source and Compass sensor selection if
applicable.
• Show the owner where the compass (or compasses) is mounted and
instruct him to keep magnetic items away.
• Show where the Mains circuit breaker is.
To Next Page
Loading...
Need help?
General
