Simrad AP35 Autopilot
62 22083083H
Reversed deflection
On installations where the rudder feedback unit is mounted upside down, the
deflection of the pointer will be reversed. To make it correct, move the
rudder to approximately 10° either way then press and hold the illumination
key for 10 (ten) seconds. The pointer will then first travel to zero then
continues to the opposite side of the scale confirmed by a 2-second beep.
Note ! If you let go of key before confirmation of reversed deflection has been
given, the RI35 Mk2 will think you meant to do a zero adjust and leave the
pointer at zero. Then simply repeat the “Zero adjust” section.
To Next Page
Loading...
Need help?
General
