Installing charts
Installing charts from the NavStick
The system is delivered with a pre-installed overview chart. Detailed world-wide charts are
available on the NavStick USB drive included with the system.
The charts are installed and maintained by using the following services:
• NavTracker - a customized web interface from NAVTOR giving the navigator and ship
management full overview of chart usage, chart update history and chart management.
The customized NavTracker web interface is created and log-on details submitted to the
user when the charts are purchased
• NavSync - a PC program from NAVTOR used for receiving and updating the content on
the NavStick
The system allows for installing and using charts in S57 and S63 format from other chart
suppliers. Refer to "Installing charts from other suppliers" on page 23.
Before the charts can be copied from the NavStick to the system the following steps must be
performed:
1. Submit the User permit code to Navico
2. Verify your chart subscription from the NavTracker web site
3. Update the content of the NavStick to include chart updates and Chart permit codes
4. Copy content of the NavStick to the system
The next sections describe the required steps in detail.
Submitting the User permit code to Navico
A chart permit code has to be obtained from Navico before the charts can be installed from
the NavStick. To obtain this code the system's User permit code must be submitted to
Navico.
The system's User permit code is automatically generated in the E5000 computer. If the
E5000 is replaced, a new User permit code has to be submitted to Navico to be able to use
the charts.
Insert a card in the SD card slot or a memory stick in the USB port on the E5000, and save the
User permit code from the System Information dialog. This code is sent to Navico by email
at chartservice@navico.com.
Ú
Note: You can NOT save the User permit code to the NavStick.
4
20
Installing charts | E50xx ECDIS Operator Manual
To Next Page
Loading...
Need help?
General
