SMA HM-20 - Page 96

13 Visualization of the energy management
SMA Solar Technology AG
Operating manualHM-20-BE-en-1996
Depending on the tab, the diagram and table show different views and data of the loads:
Tab Content
Currently
The following is required to display the tab Current:
☐ The data request interval must be set to Automatic (see Section11.3.9, page59).
Use energy meters recommended by SMA. Otherwise there may be a delay in the data being dis-
played in the Current tab.
The tab shows the following current data:
In the diagram:
• Line at the bottom of the diagram: Live data on the flow of the consumed power of each load
in the selected display period (slider).
In the table:
• Load and type of load
• Operating Mode: Operating mode of the assigned device
The button of the currently selected operating mode is highlighted in color. In addition, the LED
status is displayed via an LED symbol and the current status is explicitly stated.
The operating mode can be changed using the buttons.
If the operating mode is controlled via the SunnyHomeManager, (Automatic) appears
behind the operating mode.
If the SunnyHomeManager has switched on a load connected via a radio-controlled socket,
its start-up detection is locked for the duration of the program runtime (see Section12.3.6,
page77) and the following information is displayed: Automatic start-up detection is
locked.
• Current value of consumption: Power currently being drawn by the load
• Configuration