User Manual |
84
Laser Engraving and Cutting - 03 How to Laser Engrave and Cut
(4) Slide the scale to set the thickness of the material (1.5 mm) and tap Next.
(5) Put the Calibration Card provided or a piece of A4 paper in between the Laser Module and the material. Tap
X-, X+, Y-, Y+ to move the Laser Module above the Calibration Card. Keep adjusting the Z Offset until you feel
slight resistance when you pull out the Calibration Card, and it should be wrinkled when you push it forward.
Then, pull out the Calibration Card and tap Next.
To Next Page
Loading...
