54 SPEKTRUM DX7 • AIRCRAFT PROGRAMMING GUIDE
Automatic Landing
When the Automatic Landing Function is active, the throttle stick will activate the landing system you have
just set up. Any point of throttle stick travel can be set as the “auto-land” point. Once the throttle stick passes
through this point and the LAND switch is in the MID, or land position, the landing system will be activated.
Thus, the elevator and flaps would be activated. If the flap mixing switch is not in the LAND position, the throttle
stick operation would have no effect on the landing system.
To Activate the Automatic Landing Feature
In the flap screen, press the SELECT key until AUTO is highlighted.
Press either the INCREASE or DECREASE key to activate the AUTOMATIC LANDING SYSTEM.
To change this value, press the INCREASE or DECREASE key to adjust the value (0% = low stick while
100% = full stick).
To clear the auto land point, press CLEAR and the display will return to INH.
To Next Page
Loading...
