Assigning Mixing Values
Press the DowN and SELECT keys simultaneously to access the Function Mode.
In Function Mode, use the UP or DowN keys to select the desired PROG. MIX screen (1–3).
Press the SELECT key to highlight RATE.
Using the stick or switch that is assigned to the master channel, move that stick or switch in the desired
direction that you wish to adjust the mix value.
Press the INCREASE or DECREASE keys to adjust the mix value.
Note: If a switch is assigned to the mix, that switch must be turned on to allow mixing values to
be changed.
Moving the stick or switch in the opposite direction will allow the mix value to be adjusted in the
opposite direction.