General Operation Installation & Configuration Guide for MAXPage
b. If N is selected, all recipients within the group receive the message at the same time.
5. The first field on the next screen is Add. Type the Pager ID of a pager (or Group ID) you wish to add to this
group. You may need to press the key to enter the Pager ID if it is short. When the Pager ID has been
entered the screen shows ID added. If the Pager ID is in the group already, the screen shows ID already
included. More pagers or groups can be added by typing their ID in the Add field followed by the
key if required.
NOTE: Voice pagers (Two Tone & Group Tone) cannot be added to groups. If you wish to have a group of voice
pagers, create a new pager with the Receiver Type set to Group Tone and enter the common Group Tone for the
group of voice pagers into the cap code field.
Add[ ]Tot[ ]
Del[ ]
NOTE: The Tot field refers to the total number of ID’s within the current group.
6. Press the key to move along to the Del field. By pressing the key, you can scroll through the Pager
ID’s of pagers in the group.
7. If you wish to save the group, press the key and the screen shows Group saved.
8. If you wish to remove a Pager ID from the group, scroll through until the Pager ID is found then press the
key. The screen below is shown.
ID[1 ] remove
from group?
9. To confirm deletion, press the key again. The screen shows Member removed.
10. Press any numeric key to cancel deletion.
11. Use the key to go back to the Add field and add another pager or press the key to save the group
to the database.
The screen briefly displays the words “Group saved” once all fields have been correctly filled. You are then
returned to the Group Menu screen where you can choose to add or edit another group.
Group saved
8. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage then restarts
and is ready for use.
Deleting a Group
1. To delete a group, press to select Delete Group from the Group Menu.
1.Add/Edit Group
2.Delete Group
2. Enter the Group ID of the group you wish to delete in the ID field.
3. Click the key. If the group exists in the database the details are displayed on the screen.
To Next Page
Loading...