33
10. The first field on this screen is Encoding. This field is only used when serial input from a COMP2 or TAP
third-party paging system is being utilized and the Lookup ID field in the Main Screen|(Enter Config
Mode)|Ports|RS232|Protocol menu is set to [N]. In this case, a raw cap code is being supplied within the
protocol data, so there is no way MAXPage can determine how to encode the message in Pocsag. This field
sets the default encoding method.
Encoding [Numer]
11. Press the key to move along to the next screen.
12. The next screen is a menu screen for two-tone paging. To enter this menu screen, press , otherwise
press the key to move along to the next screen saving changes when ready, where you are taken back to
the first screen of the Transmitter Menu.
Voice Paging
Options
13. If you choose to enter the Voice Paging Options menu, the screen below displays. Two-tone pagers are
triggered by two tones sent sequentially. The fields on this screen determine the length of each of the two
tones. The first tone is usually one second or less. The second tone is usually three seconds or less. Consult
the documentation that came with your voice pagers for the optimal duration settings. The default settings
are usually sufficient in most circumstances.
A Duration[ 0.4]
B Duration[ 2.4]
14. Use the key to move between the two fields and also move onto the next screen.
15. The next screen is Gap Duration. This refers to the gap between the two tones. The default value of 0
seconds is usually sufficient for most voice pagers; however, some may need a small gap. Consult the
documentation that came with your voice pagers for the optimal duration setting.
16. Use the key to move between the two fields and also move onto the next screen.
Gap Duratn[10.0]
17. The next screen is used to configure the type of coding the two-tone pagers use. Press any key on the
keypad to toggle between TwoTn Standard and TwoTn Extended. Consult the documentation that came
with your voice pagers for the correct coding type.
Coding Type
[TwoTn Standard]
18. Press the key to save changes when ready, where you are taken back to the first screen of the
Transmitter Menu.
To Next Page
Loading...