General Operation Installation & Configuration Guide for MAXPage
19. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage then restarts
and is ready for use.
PBX
This menu is used to configure options specific to the Telephone (PBX) interface.
NOTE: The “PBX” menu item may not be available on all units as it is a licensed option. Contact your place of
purchase to enable this function.
1. At the Config Mode screen, press to choose PBX.
2. The following screen displays. This is the PBX Menu screen.
Answer after [2]
Msg per call [0]
3. The first field for editing is Answer After. Press a key between 0 and 9 on the keypad. MAXPage picks up
the phone line after the number of rings specified in this field.
4. Press the key to move along to the next field.
5. The Msg Per Call field refers to the number of messages that can be sent per call to the MAXPage unit.
Press a key between 0 and 9 on the keypad to set this.
6. Press the key to move along to the next screen.
NOTE: Entering a 0 here means an unlimited number of messages can be sent per call.
Delay prompt [0]
Call Timeout [3]
7. The first field on this next screen is Delay Prompt. Press a key between 0 and 9 on the keypad. This field
refers to the time delay (in seconds) before the voice prompt is heard once the MAXPage Telephone
interface is dialed.
8. Press the key to move along to the next field.
9. The next field is Call Timeout. This refers to the timeout of an active call if no input is made (in seconds).
10. Press a key between 0 and 9 on the keypad to set this.
11. Press the key to move along to the next screen.
2ToneTimeout[30]
12. The first field on this next screen is 2ToneTimeout. This is the length that a two-tone voice page is limited
to over the Telephone interface (in seconds). Default 30 seconds.
13. Press the key to move along to the next screen saving changes when ready. You are taken back to the
first screen of the PBX Menu.
14. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage then restarts
and is ready for use.
To Next Page
Loading...