General Operation Installation & Configuration Guide for MAXPage
3. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage restarts and is
ready for use.
COMP2
1. If COMP2 is selected, there are no options that need to be configured. Messages received by MAXPage are
automatically sent to the appropriate recipient. The following screen is shown. You are then be returned to
the RS232 Menu.
Configuration not
required
2. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage starts and is
ready for use.
SCOPE
1. If SCOPE is selected, there are no options that need to be configured. Messages received by MAXPage are
automatically sent to the appropriate recipient. The following screen is shown. You are then returned to the
RS232 Menu.
Configuration not
required
2. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage restarts and is
ready for use.
Tekk
1. If Tekk is chosen, there are no options that need to be configured. Messages received by MAXPage are
automatically sent to the appropriate recipient. The following screen is shown. You are then returned to the
RS232 Menu.
Configuration not
required
2. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage restarts and is
ready for use.
Visiplex # 1
1. If Vplex is chosen, there are no options that need to be configured. Messages received by MAXPage are
automatically sent to the appropriate recipient. The following screen is shown. You are then returned to the
RS232 Menu.
Configuration not
required
2. To return to Normal Mode, press the key three times to exit out of all menus. MAXPage restarts and is
ready for use.
ESPA
To Next Page
Loading...