2 Introduction
Use of the truck
Features of the CX-D 20
• Initial lift and main lift of 1580 mm. Allows
two pallets to be lifted at the same time.
• Max. load of 2000 kg on the initi
al lift or two
times 1000 kg on the initial lif
t AND main lift.
• Designed for Euro pallets.
• Standard lifting and lowering using a button
on the side of the truck and in the cockpit.
• Automatic speed limitation
with raised loads
to keep loads stable when tak
ing bends.
• Automatic lift cut-out at 400 mm to protect
the feet.
Use of the truck
Intended use of the trucks
CAUTION
This machine is designed for order picking (col-
lecting and gathering together items stored in the
warehouse before dispatch), horizontal transport
tasks and entering and removing pallets to and from
stock.
The dimensions and capacity of the trailers, pallets
or containers must be adapted to the load being
transported and must ensure stability.
The table of characteristics and performance
attached to this user manual gives you some of the
information you need to check that the equipment
is suitable for the work being carried out.
Any specific usage must be authorised by the
site manager; an analysis of the potential risks
associated with this usage will enable him to put in
place any necessary additional safety measures.
Approved applications
The truck can be used for lifting and carrying
loads. It is equipped with forks and allows the
fast transport of loads on the ground. The truck
may only be used as approved and described
in this manual.
If the truck is to be used in a way other than
established in the operating instructions, the
written approval of the manufacturer and,
if necessary, of the responsible authorities
14
50108043405 [EN]
To Next Page
Loading...
Need help?
General
