Still CX User Manual

Operation 5
Using the Digicode control
Using the Digicode control
123
456
789
PRG
PRG
1044_505-007
Digicode control
Access to the electronic control is granted with
three different codes:
• Driver’s code
• master code
• service code
Driver’s code
The driver’s code consists of four digits and
must be created by the Pool Manager.
It is used for the regula
r utilisation and opera-
tion of the truck by the d
river and operator.
The knowledge of the code should be re-
garded as a key and must not be misused.
The driver’s code must not be given to other
persons without express order.
The control can store a maximum of 200
driver’s codes. A driver’s code can be added
⇒ Chapter "Adding a driver’s code", P. 5-89 or
deleted ⇒ Chapter "Deleting a driver’s code
", P. 5-91 with the master code.
Master code
The master code consi
sts of four digits and is
reserved for the Poo
l Manager.
The factory setting of this code is "1234". The
pool manager is advised to replace this code
with a new master code ⇒ Chapter "Deleting
a master code", P. 5-87 or ⇒ Chapter "Adding
the master code", P. 5-86.
Like the driver’s code, it is used for the regular
operation and use of the truck, but it also
allows the addition or deletion of a driver’s
code. This control can store a maximum of
five master codes.
NOTE
If master codes or driver’s codes are forgotten
or get lost, please contact the Service Engin-
eer, for he alone can make the stored codes
visible.
50
108043405 [EN] 85

Still CX Specifications

General

Brand	Still
Model	CX
Category	Forklifts
Language	English