49
WARNING CODE CHART
Note: Warning codes will cause the printer to pause during a build. The build
may be recovered by pressing Resume in Mojo Control Panel.
Warning codes displayed in
the Mojo Control Panel Code Name Recommendation
100
101
Gantry has lost position.
1. Check for obstructions on the bellows,
modeling base and in build chamber.
2. Check that tip wipe assembly is seated
properly.
3. Check that the purge bucket is installed
correctly.
102 Z motor has lost position.
1. Check for obstructions on modeling base
and in the build chamber.
2. Check that the purge bucket is installed
correctly.
103 Model print engine following
error.
1. Press Resume.
2. If error persists, replace the model
QuickPack Print Engine.
104 Support print engine following
error.
1. Press Resume.
2. If error persists, replace the support
QuickPack Print Engine.
105
106
Gantry motor over current.
1. Check for obstructions on the bellows,
modeling base and in build chamber.
2. Check that the purge bucket is installed
correctly.
3. Check that the tip wipe assembly is
seated properly.
107 Z motor over current.
1. Check for obstructions on the modeling
base and in the build chamber.
2. Check that the purge bucket is installed
correctly.
108 Model print engine over current. Replace model QuickPack Print Engine.
109 Support print engine over
current.
Replace support QuickPack Print Engine.
112 Model temp over current. Replace model QuickPack Print Engine.
113 Support temp over current. Replace support QuickPack Print Engine.
120 Oven temp warning. Make sure room temperature is between
15°C and 30°C (59 °F and 86°F).
123–140 Low voltages. Check if AC input power is within
specifications (
“Facility specifications”
on page 54
).
To Next Page
Loading...
