2
2 OVERVIEW
The Mojo system builds models from CAD STL files that are sent to the system using a USB cable from a
dedicated host computer. The printer builds three-dimensional parts by extruding ABSplus model material and
SR-30 support material through two computer-controlled print heads, producing high quality parts that are ready
to use immediately after completion.
The Mojo system consists of two consumable QuickPack Print Engines. One QuickPack Print Engine contains
ABSplus model material and the other QuickPack Print Engine contains SR-30 support material.
Print Wizard is the preprocessing software that runs on Windows 7 or Windows 8 platforms.
Mojo builds a maximum part size of 127 x 127 x 127 mm (5 x 5 x 5 in.). Each QuickPack Print Engine contains
1311 cm³ (80 in³) of material and the extrusion head.
Power Requirements: 100-240V~, 6-3A, 50/60Hz
To Next Page
Loading...
