50
ERROR CODE CHART
148 Head fan current too low.
1. Press Resume.
2. If error persists, contact service provider.
503 Loss of move commands to the
printer.
1. Unplug and reconnect the USB cable
connection.
2. Cycle power.
3. Reboot host computer.
4. Host computer not within minimum
requirements (
“Workstation
specifications” on page 54
).
Note: Error codes will cause the printer to pause and not allow the build to start
until the error is cleared.
Error codes displayed in the
Mojo Control Panel Code Name Recommendation
2000 Move compiler error.
1. Cycle power and reboot host computer.
2. Reinstall 3D printer software.
2001 Printer not connected.
1. Verify USB cable is connected.
2. Verify the USB cable is not longer than 5
m (197 in.).
3. Unplug and reconnect the USB cable
connection.
4. Cycle power.
5. Reboot host computer.
6. Host computer not within minimum
requirements (
“Workstation
specifications” on page 54
).
2002 File not found. Reprocess STL file.
2003 Disk full. Host computer hard drive is full. Free disk
space on host computer.
2005 Door open. Close door.
2006 Cover open. Close cover.
2007 Model print engine not installed
in printer.
Install model QuickPack Print Engine.
2008 Support print engine not installed
in printer.
Install support QuickPack Print Engine.
Warning codes displayed in
the Mojo Control Panel Code Name Recommendation
To Next Page
Loading...
