Stratasys Objet260 - Starting the Printer

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-3
Figure6-1TheObjet2603DPrinter
Starting the Printer
Caution
l DonotattempttooperatetheprinterbeforebeingtrainedbyaStratasys
CustomerSupportrepresentative.
l Observeallsafetywarningsandfollowthesafetyguidelinesdescribedin
Chapter2.
1. Turnonthemainpowerswitch,locatedatthebackoftheprinter.
Figure6-2Mainpowerswitchandcable
2. Aftertheprinter-controlcomputerboots,logintoWindowsandlaunch
theprinter-controlprogram:
❒ Ontheprinter-computerdesktop,double-clicktheObjet260printer
icon.
or—
❒ FromtheStartmenu,select(All)Programs>Objet>Objet260.
AHASPplugcontainingavalidproductactivationkeyisrequiredonthe
printercomputer.Thisisinstalledatthefactoryorduringprinterupgrade.
IftheapplicationdoesnotopenandaHASPmessageappears,contact
yourdealerorStratasysCustomerSupport.