Stratasys Objet260 - Printing Modes 5

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-48
14.Afterconfirmingalloftheitemslistedinthewizardscreen,clickNext.
Printingmaterial(resin)isjettedfromeachheadanditsweightis
automaticallyrecorded.Thisprocessisrepeatedforeachprintingmode,
afterwhichthefollowingscreenappears.
Figure6-64Emptyingtheresincontainer
15.Carefullyremovetheresincontainerfromthescaleandemptyitintothe
purgeunitintheprinter.Thenreturnthecontainertothescale.
Caution: The resin in the container is uncured
l Topreventcontactwithskin,wearneopreneornitrilegloves.
l Disposeofuncuredresininaccordancewithapplicableregulations.By
emptyingthecontainerintothepurgeunit,theresinisstoredinthe
printer’ssealedwastecontainer.
16.ClosetheprinterandclickNext.
Theprintercurestheremainingresininthecontainer.
17.Whenthefollowingscreenappears,removethescaleandcleanthebuild
tray.
Figure6-65Remove the scaleconfirmationscreen