Stratasys Objet260 - Page 182

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-49
18.Inthewizardscreen,confirmthatthebuildtrayisclearandthatthe
coverisclosed,andclickNext.
Thewizardusesthedatacollectedtoanalyzetheconditionoftheprint
headsandoptimizethemsotheyprintmodelswithauniformlayerof
material.
❒ Iftheheadsareinsatisfactorycondition,thefollowingwizardscreen
appears.
Figure6-66Finalwizardscreen,afteroptimizingprintheads
❒ Ifthewizarddeterminesthataprintheadisfaulty—orthatitis
negativelyaffectingmodelqualitywiththecurrenthead
configuration—youneedtoreplaceit.Indicatewhetherornotyou
wanttodosonow.
Figure6-67Defectiveprintheadsfound
❒ ChooseReplace defective head(s)ifyouarepreparedtoreplacethe
printheadsnow(seebelow).
or—
❒ ChooseAbort wizardifyouwanttoreplacetheprintheadsatanother
time.
ReplaceprintheadsonlyafterconsultingwithaStratasys-authorized
customer-supportengineer.