Stratasys Objet260 - Shutdown Wizard

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-21
Shutdown
Wizard
ToruntheShutdownwizard:
1. StarttheShutdownwizardfromtheOptionsmenu.
Figure6-16Shutdownwizard,openingscreen
2. ClickNext.
3. Selecttheoptioncorrespondingtothelengthoftimethattheprinterwill
notbeused—lessormorethantendays.
Note: BeforeselectingMore than 10 days,makesurethatcleaning-fluid
cartridgesareavailable.
Figure6-17Shutdownoptions