Stratasys Objet260 - Symbols and Warning Labels

Objet260 User Guide 2 Safety
DOC-37004 Rev.E 2-3
Grounded Chassis Thechassisoftheprinterisgrounded,topreventelectrical
shock.
Note:Thepoweroutletmustbeproperlygrounded,in
accordancewiththelocalelectriccode,toprovidethis
protection.
IftheObjet2603Dprintingsystemisnotusedasspecifiedinthisguide,
thesafetyfeaturesmaynotprovideadequateprotection.
Symbols and Warning Labels
ThisfollowingtableliststhewarninglabelslocatedonorinObjet260
printers.
Warning Symbol Meaning Location Comments
Hazard(general) Onthenameplateonthe
backoftheprinter.
Readtheinstructionsin
thisdocumentbefore
operatingtheprinter.
Hotsurface Ontheprintblock. Riskofburns.Donot
touchthissurfaceafter
printing.
Highvoltage NeartheUVlamp
connectors.
Nearthepower-supply
enclosures.
Riskofelectricshock.
Ultraviolet
radiation
NeartheUVlamps. Riskofinjuryfrom
ultravioletradiation.
Movingparts Onthepanelthatis
visiblewhenyouopen
thefrontdoorsofthe
printer.
Riskofinjuryfrommoving
parts.