Stratasys Objet260 - Page 210

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-77
Accessing
Built-inTests
ToopentheBuilt-inTestsscreen,dooneofthefollowing:
•FromtheOptionsmenu,selectBuilt-InTests.
•PressCtrl+Alt+B.
Figure6-118SelectingBuilt-In TestsfromtheOptionsmenu
TheBuilt In Testsscreenlistspre-configuredtests,groupedbycomponent
categories.Inthisscreen,youselectandruntests,andtheresultsare
displayed.
Figure6-119Built In Testsscreen