Stratasys Objet260 - Page 33

Objet260 User Guide 4 Installing Objet Studio
DOC-37004 Rev.E 4-4
7. IntheSelect Installation Folder screen,verifythedestinationfolderand
clickNext.
Itisrecommendedthatyoudonotchangethedefaultdestinationfolder.
ClickDisk Spacetocheckthespaceinthedestinationfolder.
Figure4-4ObjetStudioinstallation-folderselection
8. IntheConfirm Installation screen,clickNexttobegininstallation.
9. IntheSelect Printer Typescreen,selectthe3Dprinterusedforproducing
modelsandclickNext.
Figure4-5Printerselection