99
It is recommended that the SwitchPoint Infinity 3 be sent to the waste treatment facility.
Refer to the WEEE Passports for the SwitchPoint Infinity 3 and SwitchPoint Infinity 3-Lite
for recycling instructions.
The Batteries Directive 2006/66/EC introduces new requirements from September 2008
on removability of batteries from waste equipment in EU Member States. To comply with
this Directive, this SwitchPoint Infinity 3 has been designed for safe removal of the
batteries at end-of-life by a waste treatment facility. Infected units should be
decontaminated before they are sent for recycling.
27.5.1 Replacing the Wireless Microphone Batteries
The SwitchPoint Infinity 3 consists of a Wireless Microphone transmitter, which has 2 AA
batteries. These batteries are intended to be removed by the end user. The Batteries
Directive 2006/66/EC introduces new requirements from September 2008 on
removability of waste batteries from equipment in EU Member States. To comply with
this Directive, this device has been designed for safe removal of the batteries by the end
user using the instructions provided herein. Infected units and batteries should be
decontaminated before they are sent for recycling.
To replace the batteries in the wireless microphone locate the battery hatch on the right
side of the unit. Slide down the eject button to open the hatch, and then replace the
batteries. Be sure to place the batteries correctly in the unit, and then close the hatch.
27.6 Damage Claims and Service
27.6.1 Damage Claims
Stryker Communications’ shipments are F.O.B. Flower Mound, TX. The equipment is
carefully packaged to prevent damage in transit.
Once the freight is accepted by the carrier, the carrier assumes all responsibility for the
safe handling and transport of the shipment. Claims related to damage that occur during
shipment must be filed directly with the carrier. The customer should examine the
shipment promptly upon receipt.
If inspection of the packaging material upon arrival reveals damage, immediately check
the unit for damage. If there is a malfunction, please return the equipment to Stryker
Communications.
To return equipment damaged in shipment:
1. Please file a damage claim with both the carrier and Stryker Communications
Customer Service.
2. Prior authorization is required for the return of any Stryker Communications
equipment. Contact Stryker Communications at 1-877-789-8106 or 1-972-410-7100.
3. Each item will be assigned a Return Merchandise Authorization (RMA). Shipments
without an RMA will be refused.
4. Repack the equipment in its original shipping container and ship prepaid and insured
to:
To Next Page
Loading...