Stryker SwitchPoint Infinity 3 - Advanced Connectivity Options; Touch Panel Interface

15
5.2.3 Audio Inputs
There are 10 audio inputs available on the front panel of the SwitchPoint Infinity 3 Router:
• Two mic level inputs
• Eight line level inputs
There are four audio inputs available on the front panel of the SwitchPoint Infinity 3-Lite
Router:
• One mic level input
• Three line level inputs
Any audio input may be used for connecting audio devices, as there are no reserved
audio inputs for specific devices. For example, the wireless microphone receiver can be
connected to any of the microphone inputs, as can the Sidne. Phantom power is
available for mic inputs. Make sure that phantom power is not enabled for microphones
that do not require it.
5.2.4 Audio Outputs
There are eight line level outputs and two speaker outputs available on the front panel of
the SwitchPoint Infinity 3 Router. Two of the line level outputs are designated for
connection to an external amplifier (applies only to SPI3). There are two line level outputs
and two speaker outputs available on the front panel of the SwitchPoint Infinity 3-Lite
Router. The Video Network Hub™ and room speakers are some of the devices that are
connected to the audio outputs on the SwitchPoint Infinity 3 Control System.
5.2.5 RS-232 Connectivity
The SwitchPoint Infinity 3 Router has 16 RS-232 ports that can be used to connect
devices that use serial communications, such as PTZ Cameras and Flat Panel monitors.
SPI3-Lite can be configured with either four or eight RS-232 ports.
5.2.6 KVM
There are three USB connections available for PC KVM control allowing for keyboard
and mouse emulation on up to three PCs.
5.2.7 Video Network Hub™
This device will facilitate room-to-room connectivity for video conferencing. If your system
is equipped with a Hub Codec, the Codec will be housed in the Video Network Hub and
will allow offsite connectivity. The Video Network Hub is connected to the SwitchPoint
Infinity 3 Control System using the Audio In and Out connectors, the Ethernet
connection, and the video input and output connectors. Details of the connection and
operation of the Video Network Hub are contained in the Operations and Maintenance
manual for that equipment.
5.2.8 SuiteLink
®
and SuiteView
®
SuiteLink is an IP-based Video Hub that coordinates Stryker endpoints with Campus
Codec functionality through an Ethernet connection. It also supports the broadcast of
video from these endpoints to IP-based desktop users in conjunction with the SuiteView