Stryker SwitchPoint Infinity 3 - Call History, Privacy, and Groups

44
10.6 Private
CCaauuttiioonn::
• Selecting the Private feature automatically disconnects any room connection.
• In order to comply with the privacy provisions of the Health Insurance Portability
and Accountability Act of 1996 (HIPAA), “Private” must be turned ON when not
actively engaged in a teleconference with another room within the OR or with
offsite locations.
If your room is not set to “Private” and somebody attempts to call you, the connection will
be made automatically.
The PPrriivvaattee button, located in the bottom left corner of the Global Taskbar, provides
control over who can view or remotely monitor the room where the SwitchPoint Infinity 3
Control System is located. The PPrriivvaattee button toggles on and off and stays highlighted in
orange when Private is On. If Private is On, the system restricts all inbound
communications. If the SwitchPoint Infinity 3 Control system is currently connected to
another room within the hospital campus or offsite location, activating the Private feature
will immediately disconnect the room.
When Private is On, you can still make outgoing calls to other rooms. The Private “On”
state is restored after the call.
If you attempt to connect to a room that is “In Private” the call must be accepted by the
callee. If nobody accepts the call, the CCaallllss SSttaattuuss button on the top right corner of the
screen will display the text “Call Failed. Touch to Cancel.” or “Remote Room is Private.”
If your room is “In Private” and somebody attempts to call, the Calls Status button will
appear on the top right corner of the screen displaying the text ,“Touch to Accept” or
“Incoming Call. Press to Accept” accompanied by an audible alert.
10.7 Last 10 Dialed
NNoottee:: BBeeffoorree sseelleeccttiinngg aann eennttrryy oonn tthhee LLaasstt 1100 DDiiaalleedd ssccrreeeenn,, pprreeppaarree tthhee oouuttggooiinngg
vviiddeeoo ssiiggnnaall wwiitthh tthhee ““WWhhaatt yyoouu sseenndd”” aanndd ““WWhheerree yyoouu sseeee iitt”” ddrroopp ddoowwnn mmeennuuss..
The Last 10 Dialed call screen displays the last 10 room or offsite calls made from that
endpoint.
To access the Last 10 Dialed screen, press the CCaallllss button on the Quick Button Bar,
and then press the Last 10 Dialed sub tab.