Stryker SwitchPoint Infinity 3 - Making a Codec Gateway Call; Waiting for an Offsite Call

48
3. Select the call “speed” or bandwidth from the “Connection Speed” drop down menu.
4. Enter the ISDN phone number using the on-screen keypad (no dashes required).
5. Press the green CCaallll button to initiate the call.
NNoottee:: PPrreessss tthhee SSttoorree NNuummbbeerr bbuuttttoonn ttoo ssttoorree tthhee ccaallll iinnffoorrmmaattiioonn ttoo CCaallll GGrroouuppss
pprreesseettss..
10.11.2Making a Codec Gateway Call
NNoottee::
•• TThhiiss sseeccttiioonn iiss oonnllyy aapppplliiccaabbllee ttoo ssyysstteemmss wwiitthh aa VViiddeeoo NNeettwwoorrkk HHuubb..
•• AA ggaatteewwaayy ccaallll iiss oonnllyy uusseedd iiff tthhee eennvviirroonnmmeenntt ccoonnttaaiinnss aa ssppeecciiaalliizzeedd HH..332200//
HH..332233 ggaatteewwaayy ddeevviiccee.. CChheecckk wwiitthh yyoouurr llooccaall IITT ddeeppaarrttmmeenntt ffoorr iinnffoorrmmaattiioonn
oonn uussiinngg tthhiiss ddeevviiccee,, aass iitt mmaayy rreeqquuiirree ccuussttoomm ccoonnffiigguurraattiioonn aanndd ddiiaalliinngg
ssttrriinnggss..
To dial a Hub Codec Gateway or Local Codec Gateway call:
1. From the Manual Dial tab, select the call type from the “Connection Type” drop down
menu.
2. Select the Codec to be used from the “Codec Name” drop down menu.
3. Select the call “speed” or bandwidth from the “Connection Speed” drop down menu.
4. Enter the gateway prefix (if required) and phone number using the on-screen keypad
(no dashes required).
5. Press the green CCaallll button to initiate the call.
NNoottee:: PPrreessss tthhee SSttoorree NNuummbbeerr bbuuttttoonn ttoo ssttoorree tthhee ccaallll iinnffoorrmmaattiioonn ttoo CCaallll GGrroouuppss
pprreesseettss..
10.11.3Waiting for an Offsite Call
The SwitchPoint Infinity 3 Control System can wait for an incoming Codec call from a
specific Codec connected to the system.
To wait for a specific incoming Codec call:
1. Press the Manual Dial tab.
2. Select WWaaiitt ffoorr OOffffssiittee CCaallll from the “Connection Method” drop down menu.
After the Codec is selected, the Control System places you in the Active Call interface
with focus on the selected Codec. When the incoming call is connected by the Codec,
the call will be complete. Use the HHaanngg UUpp button to cancel Wait for an Offsite Call or to
end a completed call.
NNoottee:: AA WWaaiitt ffoorr aann OOffffssiittee CCaallll wwiillll ttiimmee oouutt aafftteerr 3300 mmiinnuutteess iiff aa ccaallll hhaass nnoott bbeeeenn
rreecceeiivveedd..