Stryker SwitchPoint Infinity 3 - Creating and Saving Routes; PIP and Quad View Generator

29
sections: the top section shows the current route in progress (Item 1); the lower left
section shows a list of all available sources, devices, and displays (Item 3); the lower
right corner displays the video preview pane (Item 4).
7.2.1 Creating a Visual Route
To create a video route using the Visual Routing option, perform the following steps:
1. Select a source, such as the Endo Cam, from the Sources list on the left side of the
screen (Item 3). The source will be moved from the Sources area up into the Routes
area (Item 1), indicating it is the source you have selected.
2. If you only want to view the source on a display, select one, such as Monitor 1, from
the Displays list (Item 3).
NNoottee:: WWhheenn rroouuttiinngg aa ssoouurrccee ttoo aa ddeevviiccee oorr ddiissppllaayy,, eennssuurree tthhaatt tthhee vviiddeeoo ttyyppeess
ffoorr eeaacchh ccoommppoonneenntt aarree ccoommppaattiibbllee,, ootthheerrwwiissee tthhee rroouuttee wwiillll nnoott bbee ssuucccceessssffuull..
3. If you wish to route the video through a device, such as Sidne or SDC3, select it from
the Devices list, and then select a display.
4. To route a source through two devices, select the source, select each device, and
then select a display.
Each component in the route will appear in the Routes section at the top of the screen
upon selection.
7.2.2 Unrouting a Selection
To unroute an item, select it from the route and press the UUnnrroouuttee button located at the
top right corner of the Advanced Routing page. The selected item will be removed from
the current route. Repeat the procedure to unroute other items.
7.2.3 Saving a Visual Route as a Preset
To save a current route as a preset, press the SSaavvee PPrreesseett button located in the Global
Taskbar. For detailed information on saving a route as a preset,
see 9.2 Saving a Preset,
page 34
.
7.3 Text Routing
7.3.1 Creating a Text Route
To create a video route using the Text Routing option, press the Text Routing tab on the
Advanced Routing page. From this screen you will use drop down menus to select a
source, device, and display to complete the route.