S Class 2 cutter Service manual
Replacements guidelines 2-32
Add the end piece to the pinch roller bar.
Slide the pinch roller bar to the end of the machine. You may need to lift the switch
actuator to slide it in the side plate.
Lower the pinch rollers.
Fix the cam handle with the two screws while squeezing the cam handle and the
switch actuator together.
Lift the pinch rollers.
Re-apply the spring to the switch actuator.
Fit the power entry module on the side plate.
While sliding the right hand cover back over the main board, reconnect the flat cable
from the display. Secure by sliding the latch. Fix the cover with the 5 screws.
To Next Page
Loading...
