vi Sun StorageTek 2500 Series Array Hardware Installation Guide • September 2009
Next Steps 75
7. Powering On the Array 77
Before Powering On 77
Powering On the Storage Array 78
Powering Off the Array 79
Next Steps 80
8. Data Host HBAs and Software for the 2540 and 2530 Arrays 81
Data Host Software 81
HBAs and Drivers 82
Multipathing 82
Setting Up a Data Host On a Solaris System 82
▼ To Obtain Sun Solaris 9 Data Host Software 83
▼ To Install the SAN 4.4 Data Host Software 84
▼ To Obtain Software for Operating Systems Other Than Solaris 84
Installing Data Host Software for Operating Systems Other Than Solaris 85
About Data Host Software For Non-Solaris Platforms 85
Downloading and Installing Sun RDAC Software 86
Enabling Solaris Multipathing Software 86
▼ Enabling Multipathing Software for Solaris 9 OS 87
▼ Enabling Multipathing Software for Solaris 10 OS 87
Next Steps 88
9. Configuring IP Addressing 89
About IP Addressing 89
Configuring the IP Address of the Controller Modules 89
Configuring Dynamic (DHCP) IP Addressing 90
Configuring Static IP Addressing 91
Using the Serial Port Interface to Assign IP Addresses 91
To Next Page
Loading...
