Appendix C Assembly, Installation and Initial Start Up Procedures C-27
c. At the ok prompt, type:
ok reset-all<cr>
C.4 Software Installation
The information from TABLE C-3 on page C-4 as appropriate to perform the software
installation.
To install the system from the CD ROM, go to Step 25.
To install the system from a network, go to Step 26.
25. To install the system from the CD ROM, at the ok prompt, type:
ok boot cdrom <cr>
System will boot from the CD ROM and Solaris will install from the CD ROM.
Various prompts will be displayed as the system comes up, answer as
appropriate.
26. To install the system from a network boot server, the boot client Ethernet address
(the system being built) must be obtained.
a. At the ok prompt (on the system being built) type:
ok banner <cr>
This will display the Ethernet address in the following format:
X.X.XX.X.X.XX
b. Enter the address obtained in step a. in the boot server as a boot client. (See the
Solaris documentation to set up an install server).
c. At the ok prompt on the client (the system being built), type:
ok boot net <cr>
System will boot from the network and Solaris will install from the network.
Various prompts will be displayed as the system comes up, answer as
appropriate.
27. After Solaris is installed, at the ok prompt, type:
ok boot disk -rv <cr>
The system will configure itself after installation.
To Next Page
Loading...