Contents vii
5.3 Servicing the Drives Backplane 5–8
5.3.1 Removing the Drives Backplane 5–8
5.3.2 Installing the Drives Backplane 5–9
5.4 Servicing the Front Control Panel Light Pipe Assembly 5–10
5.4.1 Removing the Front Control Panel Light Pipe Assembly 5–10
5.4.2 Installing the Front Control Panel Light Pipe Assembly 5–11
5.5 Servicing the Power Distribution Board (PDB) 5–12
5.5.1 Removing the Power Distribution Board 5–12
5.5.2 Installing the Power Distribution Board 5–13
5.6 Servicing the Power Supply Backplane 5–15
5.6.1 Removing the Power Supply Backplane 5–15
5.6.2 Installing the Power Supply Backplane 5–16
5.7 Servicing the Paddle Card 5–17
5.7.1 Removing the Paddle Card 5–17
5.7.2 Installing the Paddle Card 5–18
5.8 Servicing Cables 5–19
5.8.1 Removing Drive Cables in a SAS Configuration 5–20
5.8.2 Installing HD Cables in a SAS Configuration 5–21
5.8.3 Removing a PDB Cable 5–25
5.8.4 Installing a PDB Cable 5–27
6. Returning the Server to Operation 6–1
6.1 Installing the Top Cover 6–2
6.2 Reinstalling the Server in the Rack 6–3
6.3 Returning the Server to the Normal Rack Position 6–4
6.4 Powering On the Server 6–5
A. Connector Pinouts A–1
A.1 Serial Management Port Connector A–2
To Next Page
Loading...
