Suzuki DF 40 - Tiller Handle (Df40 Qh, Df50 Qh and Df50 Wqh)

16 DF40/50 “K7” (’07) MODEL
TILLER HANDLE (DF40QH, DF50QH AND DF50WQH)
TILLER HANDLE BRACKET
The tiller handle bracket has been changed in shape and related parts.
Install the spring washers with direction as shown in figure.
Installation
1. Install the tiller handle bracket and related parts in position.
NOTE:
• Apply the thread lock to the tiller handle pivot bolt.
! 99000-32050: THREAD LOCK “1342”
• Apply the water resistant grease to the bush.
" 99000-25160: SUZUKI WATER RESISTANT GREASE
2. The tiller handle pivot bolt is tightened first to the specified
torque.
# 25 N·m (2.5 kg-m, 18.0 lb-ft)
3. Then the tiller handle pivot nut is tightened to the specified
torque.
# 45 N·m (4.5 kg-m, 32.5 lb-ft)
Tiller handle pivot bolt
25 N
.
m
(2.5 kg-m, 18.0 lb-ft)
Spring washer
Spacer
Washer
Direction of spring washers
Tiller handle bracket
Tiller handle pivot nut
45 N
.
m
(4.5 kg-m, 32.5 lb-ft)
50 N
.
m
(5.0 kg-m, 36.0 lb-ft)
25 N
.
m
(2.5 kg-m, 18.0 lb-ft)
No change
Stud bolt
Washer
Washer
Lock nut
Bush