POWER UNIT 6-12
ASSEMBLY
(1) Wash, clean and then dry all disassembled parts.
(2) Apply thin coat of engine oil to inner and outer rotors, oil
seal lip and inside surfaces of oil pump case and plate.
(3) Install outer and inner rotor to pump case.
(4) Install outer plate.
Tighten six (6) screws securely.
After mounting the outer plate, check to be sure that each
rotor turns smoothly by hand.
INSTALLATION
Installation is reverse of removal with special attention to fol-
lowing steps.
1. Check for proper timing chain installation.
(see page 6-20)
2. Install two (2) dowel pins to cylinder block.
Before fitting the pump case, oil the oil seal lip.
1
2
1. Outer rotor 2. Inner rotor
1
1
1. Dowel pin
To Next Page
Loading...
