PERIODIC MAINTENANCE 2-18
ANODES AND BONDING WIRES
Inspect every 50 hours (3 months).
ANODES
If 2/3 of the zinc anode has corroded away, replace the anode.
B
Never paint the anode.
NOTE:
The anode securing bolt should be covered with Suzuki Sili-
cone Seal.
99000-31120 : Suzuki Silicone Seal
k
BONDING WIRES
• If breakage or other damage is found on the wire, replace the
wire.
• If rust, corrosion, or other damage is found on terminal, clean
with cleaning solvent or replace the wire.
NOTE:
The insulation washer must be installed between the terminal
and the motor body.
Anode
k
Insulation washer
Bonding wire terminal
To Next Page
Loading...
