DF40QH / DF50QH 33
Release lever
Install release lever by aligning with punch mark a of release
lever and punch mark b of shaft as shown in figure.
Tighten lever bolt securely.
Tilt aid gas cylinder
Apply grease to each bush, cylinder lower shaft and cylinder
upper shaft.
Install bushes 1, 2 and cylinder lower shaft 3.
ll
ll
l99000-25160 : Suzuki Water Resistant Grease
Place the tilt aid gas cylinder in position between the clamp
brackets.
Tighten clamp bracket shaft nut to specified torque.
zz
zz
z Clamp bracket shaft nut:
43 N
.
m (4.3 kg-m, 31.0 lb.-ft.)
Slide the cylinder lower shaft bolt through the clamp bracket
and lower shaft, then secure with the nut.
Align the cylinder upper eyelet with the hole in the swivel
bracket, then insert the upper shaft through the swivel bracket
and gas cylinder.
Secure the upper shaft with the snap ring.
1 Lower shaft bolt
2 Nut
1 Upper shaft
2 Snap ring
Release leverRelease lever
To Next Page
Loading...
